Industrial instrumentation sourcing · Contact us on WhatsAppProcess, gas and airflow instruments · Review status clearly marked
TECHNICAL GUIDE · 9 MIN

Electromagnetic Flowmeter Liner and Electrode Selection Guide

A procurement framework for matching mag-meter wetted materials to conductivity, chemistry, temperature, abrasion and installation conditions.

Reviewed November 12, 2026Editorial procurement frameworkExact-model confirmation required
01

Start with the liquid, not the liner name

An electromagnetic flowmeter measures a conductive liquid by generating a magnetic field across the pipe and sensing the resulting voltage at the electrodes. The first inputs are therefore the liquid chemistry, minimum expected conductivity, normal and maximum temperature, operating pressure, solids content and the possibility of entrained air.

Describe the full process condition, not only the normal operating point. Cleaning agents, dosing excursions, flushing water, upsets and ambient conditions can change which liner and electrode materials are acceptable.

02

Use the liner to match the duty

Rubber liners are commonly considered for water and wastewater duties, while fluoropolymer liners such as PTFE or PFA are often considered where chemical resistance or higher process temperature is important. These are starting points, not universal approvals.

Confirm the proposed liner against the supplier's chemical-resistance data, temperature and pressure ratings, vacuum limits, abrasion risk and the required flange or grounding arrangement. A liner that is chemically suitable can still be unsuitable for a high-solids or high-temperature duty.

  • Record minimum and maximum process temperature, including cleaning and upset conditions.
  • State pressure, vacuum or pulsation exposure where applicable.
  • Describe solids, fibre, scale, abrasion and the expected flow velocity.
  • Ask whether the liner is available for the exact line size and connection standard.
03

Select the electrode for corrosion and wear

Common electrode options can include 316L stainless steel, Hastelloy, titanium, tantalum and platinum-iridium alloys. Their suitability depends on the specific chemistry, chloride level, oxidizing or reducing conditions, temperature and expected wear.

Do not choose an electrode from a product title or a generic corrosion chart alone. Give the actual fluid composition and concentration to the supplier, then ask for the exact electrode grade and the evidence behind the recommendation.

04

Account for grounding, installation and conductivity

The meter still needs a valid installation even when the liner and electrode are correct. Confirm grounding rings or grounding electrodes, pipe material, gasket and bolt materials, available straight run, orientation, upstream disturbances and whether the pipe remains full.

Low conductivity, non-conductive liquids, hydrogen or other bubbles, and very uneven flow can compromise the measurement principle. The quotation should state the minimum conductivity and installation conditions for the proposed model rather than assuming every liquid will work.

05

Build the RFQ evidence set

A reviewable request should include the datasheet for the exact model, liner and electrode designations, wetted-material compatibility statement, pressure-temperature limits, dimensional drawing, grounding details, calibration basis and required documentation.

Keep the requested material separate from the offered alternative. If an equivalent material is proposed, ask the supplier to identify the difference and the reason it is suitable for this duty.

  • Line size, flange standard and pressure rating.
  • Liquid composition, conductivity and temperature range.
  • Required liner, electrode and grounding materials.
  • Output, power, enclosure and calibration requirements.
  • Destination-market and hazardous-area documentation, without assuming certification.
Technical-content boundary

This guide helps collect inputs. It does not substitute for an approved drawing, datasheet, engineering review, or application-specific compatibility check.